LEMON Manuals: Even more car manuals for everyone

Installation - 1.6L

NOTE: The electrical connector must be pointed toward the front of vehicle and purge nipple must be in the up position for proper orientation of the throttle body. See Figure.
  1. Make sure that the mating surfaces for the throttle body and intake manifold are clean. See Fig 1.
    Fig 1: INTAKE MANIFOLD
    GC0019495Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the throttle body making sure that the gasket is installed in the throttle body. See Fig 2 and Fig 3. Align the pin on the manifold gasket to the pin alignment hole in throttle body, make sure that the purge nipple is pointed up and electrical connector is pointed toward the front of vehicle.
    Fig 2: THROTTLE BODY SEAL
    GC0019497Courtesy of DAIMLERCHRYSLER CORP.
    Fig 3: THROTTLE BODY SEAL INSTALLED
    GC0019496Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the 4 bolts to the throttle body. See Figure. Tighten the bolts in a cross pattern to 11.8 N.m (105 in. lbs.).
  4. Connect the vacuum line from the throttle body.
  5. Connect the electrical connectors at the throttle body.
  6. Install the clean air duct at the throttle body.
  7. Connect the negative battery cable.