LEMON Manuals: Even more car manuals for everyone

Removal And Installation

REMOVAL 

GC0200283Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the wire harness connector from the pressure sensor (1).
  2. Remove the pressure sensor from the Rear Drive Module (RDM) housing.

INSTALLATION 

GC0200283Courtesy of CHRYSLER GROUP, LLC
  1. Replace the pressure sensor with pre-applied sealant to the threads.
  2. Tighten the pressure sensor to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
  3. Connect the pressure sensor wire harness connector (1).