Arm, Lower Control: Installation
NOTE:
Installation process is the same for both sides of the vehicle.
- Install the lower control arm (5) into the front suspension crossmember (1).
- Install a NEW vertical bolt and nut (3) attaching the lower control arm (5) to the front suspension crossmember (1). Do not tighten to specification at this time.
- Install a NEW
horizontal bolt and nut (2) attaching the lower control arm (5) to the front suspension crossmember (1). Do not tighten to specification at this time. NOTE:
When raising the control arm to ride height, make sure that the ball joint boot is not damaged in the process.
- Raise the lower control arm (5) until it is at ride height, tighten the lower control arm horizontal pivot bolt (2) and then the lower control arm vertical bolt (3) to the proper torque specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
- Remove the support and lower the control arm (5).
- Install the lower load beam. Refer to LOAD BEAM, LOWER, INSTALLATION
.
- Install the lower ball joint into the knuckle.WARNING:
Make sure lower control arm ball joint stud is fully inserted into knuckle before pinch bolt is inserted into knuckle. Only ball joint stud rubber boot should be visible below the knuckle; stud should not be visible. Failure to fully and properly insert ball joint stud could lead to wheel separation and loss of mobility and could result in personal injury or death.
- Install a NEW lower ball joint pinch bolt and nut (1) and tighten to the proper torque specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
- Install the engine belly pan. Refer to BELLY PAN, INSTALLATION .
- Install the tire and wheel assembly. Refer to INSTALLATION .
- Remove the support and lower the vehicle.