Rear Outboard
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Position the rear outboard seat belt and retractor unit (5) over the stud on the rear shelf panel (3). Be certain to engage the anti-rotation tab on the retractor bracket into the clearance hole in the shelf panel.
- Install and tighten the nut (4) that secures the retractor to the stud on the shelf panel. Tighten the nut to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Install the trim (1 and 2) onto the rear shelf panel. Refer to PANEL, REAR SHELF, INSTALLATION
.
- Position the rear outboard seat belt lower anchor plate to the stud on the rear floor panel at the base of the inner C-pillar (1). Be certain the seat belt webbing is not twisted between the retractor and the lower anchor plate.
- Install and tighten the nut (6) that secures the rear outboard seat belt lower anchor plate to the stud on the rear floor panel. Tighten the nut to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Only on the same side of the vehicle as the rear outboard seat belt retractor being serviced, install the rear seat back bolster pad into the vehicle. Refer to BOLSTER, SEAT, INSTALLATION .
- Install the rear seat back into the vehicle. Refer to SEAT BACK, INSTALLATION .
- Install the rear seat cushion into the vehicle. Refer to SEAT CUSHION, INSTALLATION .