Conventional Speed Control
The vehicle operator controls all conventional speed control system features through the speed control switch pod on the face of the right horizontal spoke of the steering wheel. The Steering Column Control Module (SCCM) reads the speed control switch input via LIN, then relays an electronic speed control switch status message to the Powertrain Control Module (PCM) over the Controller Area Network (CAN) C data bus. The PCM software continually monitors these inputs as well as electronic vehicle distance message inputs from the Antilock Brake System Module (ABS) (also known as the Controller Antilock Brake/CAB, the Electronic Stability Control/ESC module or the Antilock Brake System/ABS module) and numerous hard wired inputs including the brake (stop) lamp sensor, then provides the appropriate electronic message and hard wired outputs to invoke the requested electronic speed control features. The PCM manages the Cruise Control algorithm to maintain vehicle speed established by the driver. It is also the responsibility of the PCM to send out cruise control override information and perform stuck button diagnostics.
The PCM microcontroller continuously monitors all of the speed control system electrical circuits to determine the system readiness. If the PCM detects a monitored system fault, it sets and stores a Diagnostic Trouble Code (DTC). The PCM uses On-Board Diagnostics (OBD) and can communicate with other electronic modules in the vehicle as well as with the diagnostic scan tool using the CAN data bus. This method of communication is used for control of the Malfunction Indicator Lamp (MIL) (also known as the Check Engine lamp) in the ElectroMechanical Instrument Cluster (EMIC) (also known as the Cab Compartment Node/CCN) and for system diagnosis and testing through the 16-way data link connector located on the driver side lower edge of the instrument panel.
If the ECM/PCM detects a fault on one of the following systems, it will disable the cruise control system. The ECM/PCM will store an appropriate DTC.
- Engine Speed Sensor
- Sensor or actuators of the electric throttle (only for gasoline engines)
- Accelerator Pedal Potentiometer (APP Sensor)
- Brake Pedal Position
- Clutch Switch rationality
- Engine Load sensor
- Ignition Coils
- Fuel Injectors
- Turbo sensors or actuators
Cruise Control Interaction with the Stop Start Application - The SCCM module will not be reset during a Stop Start event, which can be identified by a voltage dip down to 8V for no more than 100ms. This requirement is to maintain the system's functionality, including transmission of the cruise control switch on message to the PCM, which should not be interrupted when a Stop Start event occurs.
Downhill Cruise Control Interface
- This function helps minimize vehicle speed error during a downhill cruise event by requesting a downshift from the transmission. Downhill cruise mode is entered when the following conditions are met.
- Calibration to enable Downhill Cruise is turned on.
- Cruise is on, enabled and in regulation mode.
- Cruise control is not an override, resume or accel modes.
The hard wired inputs and outputs for the PCM may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information. However, conventional diagnostic methods will not prove conclusive in the diagnosis of the PCM or the electronic controls or communication between other modules and devices that provide features of the conventional speed control system. The most reliable, efficient, and accurate means to diagnose the PCM or the electronic controls and communication related to speed control system operation requires the use of a diagnostic scan tool. Refer to the appropriate diagnostic information.