LEMON Manuals: Even more car manuals for everyone

Pump Motor Installation

WARNING: This page is about a different car, the 2015 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Motor And Pump Assembly O-Rings
GC0159653Courtesy of CHRYSLER GROUP, LLC
NOTE:

The pump motor assembly O-rings must be replaced. The O-rings are of different size and must not be interchanged. the red O-ring (3) goes on first and is nearest the pump flange, followed by the blue O-ring (4) that sits nearest the outboard edge. 

  1. Install NEW  pump motor O-rings.
    Fig 2: Pump Motor Assembly
    GC0160122Courtesy of CHRYSLER GROUP, LLC
  2. Install the pump motor assembly (1) onto the Rear Driveline Module (RDM).
    Fig 3: Motor To Pump Fasteners & Pump Motor Bolts
    GC0160053Courtesy of CHRYSLER GROUP, LLC
  3. Install the three pump motor bolts (1) and uniformly finger tighten until the pump motor assembly is fully seated to housing. Tighten to the proper specifications. Refer to SPECIFICATIONS .
    Fig 4: Identifying Pressure Sensor And Pump Motor Electrical Connectors
    GC0159204Courtesy of CHRYSLER GROUP, LLC
  4. Connect the pump motor wire harness connector (2).
    CAUTION:

    Do not mix hydraulic fluid and the RDM lubricant. Use only recommended fluid to prevent damage to Rear Driveline Module components. Fluid must meet material specification MS-2155.

  5. Top off the hydraulic fluid and bleed the hydraulic system. Refer to FLUID, HYDRAULIC, STANDARD PROCEDURE .