LEMON Manuals: Even more car manuals for everyone

Throttle Body: Installation: 3.6L

GC0144240Courtesy of CHRYSLER GROUP, LLC
  1. Check the condition of the throttle body-to-intake manifold seal (1). The seal can be reused if not damaged.
  2. Clean the mating surfaces of the throttle body and intake manifold.
    GC0144237Courtesy of CHRYSLER GROUP, LLC
  3. Position the throttle body (2) to the intake manifold.
  4. Install the throttle body mounting bolts (3) and tighten in a crisscross pattern sequence to the proper torque specification. Refer to FUEL INJECTION, GAS, TECHNICAL SPECIFICATIONS .
  5. Connect the wire harness connector (1) to the Electronic Throttle Control (ETC) (2) and secure the ETC harness to the clip (4) on the throttle body.
    GC0159796Courtesy of CHRYSLER GROUP, LLC
  6. Position the resonator housing (6) onto the ball stud.
  7. Install the resonator bolt (2) and tighten to the proper (Torque Specifications).
  8. Hand tighten the clamp (4) at the air cleaner housing.
  9. Hand tighten the clamp (3) at the throttle body.
  10. Connect the Intake Air Temperature (IAT) sensor wire harness connector (1).
    GC0159742Courtesy of CHRYSLER GROUP, LLC
  11. Position the engine cover (1) and secure the retaining grommets onto the ball studs (2).
  12. Connect the negative battery cable.
  13. Use a scan tool to clear all Diagnostic Trouble Codes (DTC) and perform Electronic Throttle Control (ETC) relearn function.