LEMON Manuals: Even more car manuals for everyone

Throttle Body: Installation: 2.4L

GC0156297Courtesy of CHRYSLER GROUP, LLC
  1. If necessary, Install a new throttle-to-intake manifold gasket (1).
    GC0155543Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    DO NOT OVER TORQUE. Over tightening can cause damage to the throttle body, gaskets, bolts or the intake manifold.

  2. Install throttle body (3). Tighten four bolts (1, 2) finger tight.
    Fig 1: Throttle Body Tightening Sequence
    GC0080450Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    The throttle body must be torqued in a mandatory torque sequence shown in illustration. Tighten in a criss - cross pattern to specification.

  3. Tighten the bolts in criss cross pattern to the proper torque specification. Refer to FUEL INJECTION, GAS, TECHNICAL SPECIFICATIONS .
    GC0155590Courtesy of CHRYSLER GROUP, LLC
  4. Install throttle body support bracket (2), bolt (3) and nut (1). Tighten fasteners to:
    GC0155766Courtesy of CHRYSLER GROUP, LLC
  5. Install wire harness retainer (3) to throttle body (2) and connect the throttle body wire harness connector (1).
  6. Install the air cleaner resonator assembly. Refer to INSTALLATION .
  7. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  8. Use a scan tool to clear all Diagnostic Trouble Codes (DTC) and perform Electronic Throttle Control (ETC) relearn function.