Module, Blind Spot: Removal
- Disconnect and isolate the negative cable from the battery.
- Remove the closeout panel secured between the body and the outboard lower flange of the rear bumper fascia.
- Reach up behind the outboard end of the rear bumper fascia to access and disconnect the rear bumper fascia wire harness connector (4) from the Left Blind Spot Sensor (LBSS) or Right Blind Spot Sensor (RBSS) (3) connector receptacle.
- Disengage the latch tabs (2) of the sensor mounting bracket and pull the LBSS or RBSS out of the bracket.