LEMON Manuals: Even more car manuals for everyone

Throttle Body: Installation: 3.6L

Fig 1: Throttle Body-To-Intake Manifold Seal
GC0144240Courtesy of CHRYSLER GROUP, LLC
  1. Check the condition of the throttle body-to-intake manifold seal (1). The seal can be reused if not damaged.
  2. Clean the mating surfaces of the throttle body and intake manifold.
    Fig 2: Electrical Connector, Electronic Throttle Control, Clip & Mounting Bolts
    GC0144237Courtesy of CHRYSLER GROUP, LLC
  3. Position the throttle body (2) to the intake manifold.
  4. Install the throttle body mounting bolts (3) and tighten in a crisscross pattern sequence to the proper specification. Refer to FUEL INJECTION, GAS, SPECIFICATIONS .
  5. Connect the wire harness connector (1) to the Electronic Throttle Control (ETC) (2) and secure the ETC harness to the clip (4) on the throttle body.
    Fig 3: IAT Sensor Connector, Throttle Body & Air Inlet Hose Housing
    GC0159796Courtesy of CHRYSLER GROUP, LLC
  6. Position the resonator housing (6) onto the ball stud.
  7. Install the resonator bolt (2) and tighten to the proper Torque Specifications.
  8. Hand tighten the clamp (4) at the air cleaner housing.
  9. Hand tighten the clamp (3) at the throttle body.
  10. Connect the Intake Air Temperature (IAT) sensor wire harness connector (1).
    Fig 4: Engine Cover & Ball Studs
    GC0159742Courtesy of CHRYSLER GROUP, LLC
  11. Position the engine cover (1) and secure the retaining grommets onto the ball studs (2).
  12. Connect the negative battery cable.
  13. Use a scan tool to clear all Diagnostic Trouble Codes (DTC) and perform Electronic Throttle Control (ETC) relearn function.