LEMON Manuals: Even more car manuals for everyone

ARM, Upper Control: Installation: Installation

NOTE: Although All-Wheel-Drive and Rear-Wheel-Drive upper control arms are similar in appearance, they are not interchangeable.
Fig 1: Identifying Upper Control Arm, Bolts, Bracket & Shock Tower
GC0079727Courtesy of CHRYSLER LLC
  1. Slide upper control arm (2) into bracket (3) located in shock tower (4).
  2. Install upper control arm mounting (flag) bolts (1) through bracket, arm and tower. Position flags on bolt heads outward, toward wheel opening.
    Fig 2: Headlamp Leveling Sensor, Electrical Connector, Bracket, And Upper Control Arm
    GC0079726Courtesy of CHRYSLER LLC
  3. Export Only - If servicing right upper control arm, connect headlamp leveling sensor (2) link at upper control arm (1).
    Fig 3: Identifying Nut, Upper Ball Joint Stud, Shock Assembly & Shock Tower
    GC0079691Courtesy of CHRYSLER LLC
  4. Move shock assembly (3) allowing studs to be inserted through shock tower (2) mounting holes.
  5. Place upper ball joint stud (1) through hole in top of knuckle and install nut (4). Tighten nut by holding ball joint stud with a hex wrench while turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 47 N.m + 90° turn (35 ft. lbs. + 90° turn).
    Fig 4: Identifying Routing Clip, Brake Tube Bracket, Wheel Speed Sensor & Body Connector
    GC0079718Courtesy of CHRYSLER LLC
  6. Connect wheel speed sensor cable routing clip (2) at brake tube bracket (3).
    Fig 5: Tire And Wheel Mounting
    GC0079683Courtesy of CHRYSLER LLC
  7. Install tire and wheel assembly (1). Refer to Tires and Wheels - Installation . Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) (Police - 190 N.m (140 ft. lbs.)).
  8. Lower vehicle to curb position.
    Fig 6: Upper Control Arm Mounting Nuts
    GC0079725Courtesy of CHRYSLER LLC
  9. Install nuts (2) on upper control arm body mounting bolts (1). Tighten nuts to 75 N.m (55 ft. lbs.).
    Fig 7: Identifying Front Shock Tower Cap, Shock Assembly, Nuts & Shock Tower
    GC0079716Courtesy of CHRYSLER LLC
  10. Install three nuts (2) fastening shock assembly (4) to shock tower (3). Tighten nuts to 27 N.m (20 ft. lbs.).
  11. If equipped, align shock tower cap (1) with shock mounting nuts (2) and snap into place.
  12. If installing left upper control arm, install coolant recovery container. Refer to Cooling/Engine/BOTTLE, Coolant Recovery - Installation
  13. If installing right upper control arm, install IPM.