LEMON Manuals: Even more car manuals for everyone

Installation - 3.3/3.8L

  1. Before installing an injector the rubber O-ring must be lubricated with a drop of clean engine oil to aid in installation.
  2. Install injector clip by sliding open end into the top slot of the injector. The edge of the receiver cup will slide into the side slots of clip. See Figure.
  3. Install injectors into cups of fuel rail and check to ensure retaining clips are securely attached. Be careful not to damage O-ring during installation. See Figure.
  4. Repeat steps for remaining injectors.
  5. Install fuel rail, refer to Fuel Rail in FUEL DELIVERY  .
  6. Connect fuel injector wiring.
  7. Install the Intake Manifold, (Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) - UPPER(Refer to ENGINE/MANIFOLDS/INTAKE MANIFOLD - INSTALLATION) - LOWER
  8. Connect the negative battery cable.