LEMON Manuals: Even more car manuals for everyone

Fuel Pressure Regulator: Removal

NOTE: THE FUEL PRESSURE REGULATOR IS ON THE PASSENGER SIDE OF THE FUEL TANK.
  1. Release the fuel pressure, refer to STANDARD PROCEDURE - FUEL SYSTEM PRESSURE RELEASE PROCEDURE  .
  2. Disconnect negative battery cable.
    Fig 1: Fuel Tank Assembly
    GC0000382Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove fuel tank. See Fig 1, (Refer to FUEL SYSTEM/FUEL DELIVERY/FUEL TANK - REMOVAL) .
  4. Vacuum area before removing module lock ring.
  5. Disconnect lines from top of the module.
    Fig 2: Locking Ring Contact Points
    GC0000364Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove module lock ring. See Fig 2.
    NOTE: Use a brass punch to remove the 1/4 turn lock ring.
  7. Drain fuel tank, use an approved gasoline draining station.
  8. Remove module from fuel tank.
    Fig 3: Regulator Ground Removal
    GC0000377Courtesy of DAIMLERCHRYSLER CORP.
  9. Remove wire from side of regulator, depressed tab on the connector in order to remove the ground wire. See Fig 3.
    Fig 4: Ground Removed
    GC0000378Courtesy of DAIMLERCHRYSLER CORP.
  10. Ground wire removed. See Fig 4.
  11. Use a socket to compress the 4 tabs that retain regulator.
  12. Pry up regulator and remove regulator and o-rings.