LEMON Manuals: Even more car manuals for everyone

Installation (Column Shift)

  1. Make sure transaxle shift lever is in "Park." This is the most rearward position. Verify park sprag is fully engaged by rotating either a tire or an axle shaft.
  2. Position cable in vehicle and connect cable end to the transaxle shift lever. See Figure .
  3. Verify that the washer is still in place on the cable mounting stud. Install cable to transaxle and tighten nut to 250 INCH Lbs. (28 N.m).
  4. Rotate fill tube to original location. Install and tighten fill tube bracket bolt.
  5. Install cable "push pin" into bracket. See Figure .
  6. Route transaxle shift cable through hole in dash panel. See Figure and Fig 1 .
  7. Lubricate cable grommet with a synthetic lubricant (or equivalent) and secure to hole. Verify that it is seated by pulling outward on cable.
  8. Install cable into throttle/gearshift cable bracket. See Figure .
  9. Inside the vehicle, route the gearshift between the left A/C duct and the left lower heat duct and up to the steering column.
  10. Tilt steering column all the way up and make sure shift lever is still in "Park".
  11. Connect transaxle shift cable to shift cable conduit bracket and secure with new clip. See Figure .
  12. Attach shift cable to attaching stud (pin) by snapping into place. See Figure .
  13. Move the steering column to full tilt downward. Put the column shifter in park with key removed.
  14. Adjust cable by rotating the adjuster into lock position. The adjuster will click when lock is fully adjusted. See Fig 2 .
  15. Reinstall upper and lower steering column shrouds. Then install underpanel silencer/duct. See Figure and Figure .
  16. Check shifter for proper operation. It should operate smoothly without binding. The engine starter should crank in park or neutral positions only.
Fig 1: Routing Shift Cable
G00368154Courtesy of CHRYSLER CORP.
Fig 2: Rotating Adjuster
G00368155Courtesy of CHRYSLER CORP.