LEMON Manuals: Even more car manuals for everyone

Cylinder Head Cover(S): Installation

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean cylinder head and cover mating surfaces. Inspect and replace gasket and seals as necessary (Fig 1).
    Fig 1: Identifying Cylinder Head Cover Gasket And Spark Plug Tube Seals
    G02709729Courtesy of DAIMLERCHRYSLER CORP.
  2. To replace spark plug tube seals:
    1. Using a suitable pry tool, carefully remove tube seals.
    2. Position new seal with the part number on seal facing cylinder head cover.
    3. Install seals using Special Tool MD-998306 (Fig 2).
    Fig 2: Installing Spark Plug Tube Seal
    G02709730Courtesy of DAIMLERCHRYSLER CORP.
  3. Install cylinder head cover bolts and tighten to 12 N.m (105 in. lbs.) (Figure).
  4. For right cylinder head cover installation perform the following:
    1. Position A/C compressor on bracket and install mounting bolts.
    2. Install A/C compressor belt.
  5. Position wire harness on cylinder head cover and install retaining nuts (Figure).
  6. Install ignition coils and connect all electrical connectors (Figure).
  7. Install upper intake manifold. (Refer to INTAKE MANIFOLD - UPPER ).
  8. Install air cleaner assembly.