LEMON Manuals: Even more car manuals for everyone

Section 103 (3.5L): Crankshaft: Removal

WARNING: This page is about a different car, the 2003 Dodge Intrepid, 2003 Chrysler Intrepid, 2003 Chrysler Concorde, and 2003 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine from vehicle. (Refer to REMOVAL )
  2. Remove oil pan. (Refer to REMOVAL ).
  3. Remove oil pickup tube.
  4. Remove crankshaft vibration damper. (Refer to REMOVAL ).
  5. Remove idler pulley for accessory drive belt.
  6. Remove front lower timing belt cover.
  7. Remove front main timing belt cover.
  8. Remove front left side timing belt cover.
  9. Remove timing belt tensioner and timing belt.
  10. Remove crankshaft sprocket. (Refer to REMOVAL ).
  11. Tap dowel pin out of crankshaft.
  12. Remove oil pump assembly.
  13. Remove crankshaft rear oil seal retainer. (Refer to REMOVAL ).
  14. Remove connecting rod bearing caps. Connecting rod bearing caps are not interchangeable and should be marked before removal to insure correct assembly (Fig 1).
    Fig 1: Identifying Connecting Rod To Cylinder Identification
    G02709767Courtesy of DAIMLERCHRYSLER CORP.
  15. Remove main bearing caps. Main bearing caps are not interchangeable and are marked to insure correct assembly (Fig 2).
    Fig 2: Identifying Tie Bolts
    G02709768Courtesy of DAIMLERCHRYSLER CORP.
  16. Remove crankshaft from cylinder block (Fig 3).
    Fig 3: Identifying Engine Block And Crankshaft
    G02709769Courtesy of DAIMLERCHRYSLER CORP.
NOTE: Before installing crankshaft, refer to Fitting Main Bearings and Installation of Connecting Rod Bearings. (Refer to STANDARD PROCEDURE ) or (Refer to STANDARD PROCEDURE ).