LEMON Manuals: Even more car manuals for everyone

DTC P0206: Injector No. 6 Control Circuit: Testing

NOTE: Record freeze frame data that set along with DTC.
  1. Turn ignition on. Using scan tool, read DTCs. If GOOD TRIP counter is displayed and equal to zero, go to next step. If GOOD TRIP counter is not displayed and equal to zero, go to step  7.
  2. Turn ignition off. Disconnect injector No. 5 harness connector. Turn ignition on. Using scan tool, actuate ASD relay. Connect a test light between ground and ASD relay output circuit (Dark Green/Light Green wire) at injector No. 6 harness connector. If test light flashes brightly, go to step  4. If test light does not flash brightly, go to next step.
  3. Turn ignition off. Remove ASD relay from Power Distribution Center (PDC). PDC is located in engine compartment, next to air cleaner. See Figure. Connect a test light between positive battery terminal and ASD relay output circuit (Dark Green/Light Green wire) at injector No. 6 harness connector. If test light illuminates brightly, go to next step. If test light does not illuminate brightly, repair open in ASD relay output circuit.
  4. Turn ignition off. Disconnect PCM harness connectors. PCM is located in engine compartment, to left of air cleaner. Measure resistance of injector No. 6 driver circuit (Brown/Dark Blue wire) between injector No. 6 harness connector and terminal No. 14 at PCM C1 harness connector. See Figure. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Brown/Dark Blue wire.
  5. Measure resistance between ground and injector No. 6 driver circuit (Brown/Dark Blue wire) at injector No. 6 harness connector. If resistance is 100 k/ohms or more, go to next step. If resistance is less than 100 k/ohms, repair short to ground in Brown/Dark Blue wire.
  6. Using scan tool, clear DTCs. Turn ignition off. Replace fuel injector. Attempt to operate vehicle using information noted in freeze frame. Using scan tool, read DTCs. If DTC P0206 resets, replace PCM. If DTC P0206 does not reset, test is complete.
  7. Conditions that set DTC are not present at this time. Perform the following to help identify intermittent condition:
    • With engine running at normal operating temperature, wiggle related wiring harness while monitoring related parameters on scan tool. If voltage changes or DTC sets while wiggling wiring harness, repair connectors or wiring harness where wiggling caused voltage to change or DTC to set.
    • Review freeze frame information on scan tool. Duplicate conditions present when DTC was set.
    • Refer to any technical service bulletins that may apply.
    • Visually inspect related wiring harness. Check for chafed, pierced, pinched or partially broken wires.
    • Visually inspect related wiring harness connectors. Check for broken, bent, pushed out or corroded terminals.

    If a problem is found, repair as necessary. If no problems are found, test is complete.