Clutch Assembly: Inspection
- Check for oil leakage through engine rear main bearing oil seal and transaxle input shaft seal. Check flywheel and pressure plate for burned areas, discoloration, cracks, grooves or ridges. Replace as necessary.
- Use medium sandpaper (80-180 grade) to clean flywheel surface, then wipe with mineral spirits. DO NOT flat-machine flywheel surface. Check facing surfaces for grease or oil contamination. Check for wear to within less than .008" (.20 mm) of rivet heads. Check splines of disc hub and transaxle input shaft.
- Using straightedge, check pressure plate. Friction area should be flat to slightly concave, with inner diameter about 0-.0039" (0-0.1 mm) less than outer diameter. Using surface plate, check clutch cover for flatness. Sections around bolt holes should contact surface plate within .015" (.38 mm). Ensure cover-to-flywheel dowel fit is snug. Replace clutch assembly as necessary.
NOTE:
Before installing clutch disc, ensure flywheel mating surface, pilot bearing/bushing and clutch release bearing are okay. Repair and/or replace components as necessary.
NOTE:
Clutch release bearing is packed with grease. DO NOT use cleaning solvent to clean release bearing.