LEMON Manuals: Even more car manuals for everyone

Fuse & Electrical Short Test

  1. Turn engine off. Remove and inspect EBL (rear defogger) fuse from Power Distribution Center (PDC). PDC is located in engine compartment. See PDC cover label for fuse location. If fuse is open, go to next step. If fuse is not open, go to REAR WINDOW DEFOGGER RELAY TEST  .
  2. Locate rear window grid negative lead-to-ground lug. Remove ground lug screw. Isolate ground lug. Using an ohmmeter, check resistance between ground and ground lug. If resistance is less than 10 ohms, rear defogger grid is shorting to ground. Replace rear defogger grid. If resistance is more than 100 ohms, go to step  4 . If resistance is not as specified, go to next step.
  3. Disconnect rear defogger grid voltage feed wire from wiring harness. If resistance is still less than 10 ohms, rear defogger grid is shorting to ground. Replace rear defogger grid. If resistance is more than 100 ohms, go to next step.
  4. At this time, a problem exists in circuits to rear defogger relay. Using an ohmmeter, check circuits to rear defogger relay. See WIRING DIAGRAMS  . Repair circuits as necessary. If circuits are okay, replace EBL fuse.