Test NS-2A - Checking Fuel System
NOTE:
Perform TEST DTC before proceeding.
WARNING:
High fuel pressure may be present in fuel lines. Open fuel system with caution. See FUEL PRESSURE RELEASE procedure in SELF-DIAGNOSTICS section in this article.
- Ensure throttle cables are not holding throttle open. If throttle is being held open, repair as necessary. Perform TEST VER-1A. If throttle is not being held open, go to next step.
- Using scan tool, read Throttle Position (TP) sensor voltage. If voltage is more than 1.2 volts, replace TP sensor. Perform TEST VER-1A. If voltage is 1.2 volts or less, go to next step.
- Using scan tool, read theft security system status. If scan tool shows fuel is on, go to next step. If scan tool does not show fuel is on, perform theft security system test. See appropriate ANTI-THEFT SYSTEMS article in ACCESSORIES & EQUIPMENT section. If anti-theft system article does not find a problem with theft alarm, replace Powertrain Control Module (PCM). Perform TEST VER-1A.
- Using scan tool, actuate ASD fuel system test. Check for fuel pump operation at fuel tank. If fuel pump operates, go to next step. If fuel pump does not operate, go to TEST NS-5A.
- Using scan tool, stop ASD fuel system actuation. Turn ignition off. Ensure fuel tank is at least 1/4 full before performing this test. Release fuel pressure. Connect Fuel Pressure Adapter (C-4799-B) to fuel rail.
- On all vehicles, turn ignition on. Using scan tool, actuate ASD fuel system test. Observe and record fuel pressure. See FUEL PRESSURE SPECIFICATION table. Go to next step.
- If fuel pressure is within specification, go to next step. If fuel pressure is more than specification, replace fuel pressure regulator/filter. Perform TEST VER-1A. If fuel pressure is less than specification, perform TEST NS-4A.
- Using scan tool, stop ASD fuel system actuation. Attempt to start vehicle. If vehicle started and stalled repeatedly, go to TEST NS-7A. If vehicle did not start and stall repeatedly, fuel pressure is okay. Go to TEST NS-3A.