LEMON Manuals: Even more car manuals for everyone

Test TC-87A - Speed Control Switch Always Low

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in SELF-DIAGNOSTICS section in this article. For wiring diagram, see WIRING DIAGRAMS - 2.7L article.
  1. Using scan tool, read speed control switch volts. If voltage is less than one volt, go to step 3). If voltage is one volt or more, go to next step.
  2. Condition to set trouble code is not present at this time. SPEED CONTROL SWITCH ALWAYS LOW DTC sets if speed control switch voltage is less than 4.5 volts for 2 minutes. Possible causes are: speed control switch circuit shorted, Powertrain Control Module (PCM) failure, shorted speed control switch signal circuit, or shorted speed control switch. See INACTIVE TROUBLE CODE CONDITION in SELF-DIAGNOSTICS section in this article. Test is complete. Perform TEST VER-4A.
  3. Disconnect speed control on/off switch 2-pin connector. Observe scan tool voltage reading. If voltage changed to 5 volts, replace speed control on/off switch. Perform TEST VER-4A. If voltage did not change to 5 volts, go to next step.
  4. Disconnect speed control resume/accel switch. Observe scan tool voltage reading. If voltage changed to 5 volts, replace speed control resume/accel switch. Perform TEST VER-4A. If voltage did not change to 5 volts, go to next step.
  5. Turn ignition off. Using an ohmmeter, check resistance between speed control on/off switch 2-pin connector terminals (PCM side). See SPEED CONTROL SWITCH CONNECTOR WIRE IDENTIFICATION table. If resistance is 5 ohms or more, go to TEST TC-87B. If resistance is less than 5 ohms, repair short to ground on speed control switch signal circuit. Perform TEST VER-4A.
SPEED CONTROL SWITCH CONNECTOR WIRE IDENTIFICATION

Application Wire Color
Speed Control Switch Signal Circuit White
Ground Circuit Black