LEMON Manuals: Even more car manuals for everyone

Test TC-21A - Injector Control Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION in SELF-DIAGNOSTICS section in this article. For wiring diagram, see WIRING DIAGRAMS - 2.7L article.
  1. Start engine. Allow engine to idle for at least 20 seconds. Using scan tool, read Diagnostic Trouble Codes (DTCs). If scan tool displays GLOBAL GOOD TRIP and is equal to zero, go to step 5). If scan tool does not display GLOBAL GOOD TRIP and is not equal to zero, go to next step.
  2. Condition to set trouble code is not present at this time. INJECTOR CONTROL CIRCUIT DTC sets if no inductive kick is sensed .18 milliseconds after injector turn off with no other injectors on. This DTC takes .64-10 seconds to set. Possible causes are: open or shorted injector driver circuit, open injector, open ASD supply voltage at injector, Powertrain Control Failure (PCM) failure, faulty connections or wiring. Go to next step.
  3. Inspect all related wiring and connectors and repair as necessary. If no problems were found with wiring and connectors, go to next step. If related wiring and connectors were repaired, perform TEST VER-2A.
  4. With engine idling, wiggle wiring harness from fuel injectors to PCM. If wiggling caused engine to misfire or stall, repair wiring harness as necessary where wiggling caused problem to appear. Perform TEST VER-2A. If wiggling did not cause misfire or stall, see INACTIVE TROUBLE CODE CONDITION in SELF-DIAGNOSTICS section in this article. Check freeze frame data and determine conditions present when code was set. Attempt to duplicate freeze frame conditions for additional diagnostics. Test is complete. Perform TEST VER-2A.
  5. See INJECTOR TROUBLE CODE table.
INJECTOR TROUBLE CODE

Trouble Code Go To
INJECTOR NO. 1 CONTROL CIRCUIT TC-21B 
INJECTOR NO. 2 CONTROL CIRCUIT TC-20A 
INJECTOR NO. 3 CONTROL CIRCUIT TC-19A 
INJECTOR NO. 4 CONTROL CIRCUIT TC-61A 
INJECTOR NO. 5 CONTROL CIRCUIT TC-69A 
INJECTOR NO. 6 CONTROL CIRCUIT TC-70A