Test TC-15B - Speed Control Solenoid Circuits
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION in SELF-DIAGNOSTICS section in this article. For wiring diagram, see WIRING DIAGRAMS - 2.7L
article.
- Using an ohmmeter, check resistance of speed control brake switch output circuit between brake switch connector and speed control servo 4-pin connector. See SPEED CONTROL SERVO CONNECTOR WIRE IDENTIFICATION table and BRAKE SWITCH CONNECTOR WIRE IDENTIFICATION table. If resistance is 5 ohms or less, go to next step. If resistance is more than 5 ohms, repair open brake switch output circuit. Perform TEST VER-4A.
- Check brake switch adjustment. See appropriate DISC & DISC article in BRAKES section. If brake switch adjustment is okay, replace brake switch. Perform TEST VER-4A. If brake switch adjustment is not okay, adjust brake switch as necessary. Perform TEST VER-4A.
SPEED CONTROL SERVO CONNECTOR WIRE IDENTIFICATION
| Application | Wire Color |
|---|---|
| Brake Switch Output Circuit | Dark Blue/Red |
| Vacuum Solenoid Control Circuit | Tan/Red |
| Vent Solenoid Control Circuit | Light Green/Red |
| Ground | Black |