Power Steering Pump Overhaul: Reassembly
- Using Oil Seal Installer (MB991203), install NEW oil seal. To complete installation, reverse removal procedure. Use NEW "O" rings lubricated with clean transmission fluid.
- Install rotor on drive shaft so that punch mark faces pump cover side. After installation of snap ring, lift rotor and ensure snap ring has entered countersunk part. Install cam ring with punch mark toward side plate. Install vanes in rotor with round edge toward cam ring.
- Install tabs of wave washer in cavities of side plate. Align dowel pin hole of side plate with dowel pin of pump body. Install protrusions of seal washer in cavities of pump body. Bleed system and check for leaks. See HYDRAULIC SYSTEM BLEEDING
under LUBRICATION.
Courtesy of CHRYSLER CORP.
- Using Oil Seal Installer (MB991203), install NEW oil seal. Using Needle Bearing Installer (MB990956) and Adapter (MB991172), press-fit drive shaft. Use NEW snap ring. To complete installation, reverse removal procedure. Use NEW "O" rings lubricated with clean transmission fluid. Install pressure switch assembly with larger end of spring facing up.
- Install rotor on drive shaft so that punch mark faces pump cover side. Install cam ring with punch mark toward side plate. Install vanes in rotor with round edge toward cam ring. Use NEW seal washer. Bleed the hydraulic system and check for leaks. Refer to HYDRAULIC SYSTEM BLEEDING
under LUBRICATION.
Courtesy of CHRYSLER CORP.