LEMON Manuals: Even more car manuals for everyone

A/C Pressure Sensor Volts Too Low (DTC 33)

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS - 3.5L article in ENGINE PERFORMANCE. After each repair, perform TEST VER-2  .
  1. With the DRB, read the A/C pressure sensor voltage. If the A/C pressure sensor voltage is below 0.2 volt, go to step  3 . If the A/C pressure sensor voltage is not below 0.2 volt go to next step.
  2. Using the wiring diagram as a guide and wiggle A/C pressure sensor connector and harness. See AIR CONDITIONING in appropriate SYSTEM WIRING DIAGRAM article. Monitor the DRB display. If there is any change in A/C pressure sensor voltage, repair the harness or connector that caused the voltage change. If there was not any change in A/C pressure sensor voltage, go to step  7 .
  3. Disconnect the A/C pressure sensor connector. See Figure . With the DRB in voltmeter mode, probe the 5-volt supply circuit. See Fig 1 . If the A/C pressure sensor 5-volt supply circuit is not above 4.9 volts, repair the open 5-volt supply circuit. If the A/C pressure sensor 5-volt supply circuit is above 4.9 volts, go to next step.
    Fig 1: Identifying A/C Pressure Sensor Connector Terminals
    G00381022Courtesy of CHRYSLER CORP.
  4. Ensure that the A/C pressure sensor connector is still disconnected. With the DRB, read the A/C pressure sensor voltage. If the A/C pressure sensor voltage is above 4.5 volts, replace the A/C pressure sensor. If the A/C pressure sensor voltage is not above 4.5 volts, go to next step.
  5. Turn ignition off. Disconnect the PCM. See Figure . With the DRB in ohmmeter mode, probe the A/C pressure sensor signal circuit. See Fig 1 . If the resistance is below 5.0 ohms, repair the sensor signal circuit for a short to ground. If the resistance is not below 5.0 ohms, go to next step.
  6. Using an ohmmeter, test the resistance between the A/C pressure sensor signal circuit and the sensor ground circuits. See Fig 1 . If the resistance is below 5.0 ohms, repair the sensor signal circuit shorted to the sensor ground circuit. If the resistance is not below 5.0 ohms, replace the PCM.
  7. The condition required to set the code is not present. Using the wiring diagram as a guide, inspect the wiring and connectors. See AIR CONDITIONING in appropriate SYSTEM WIRING DIAGRAM article. If any problems were found, repair as necessary. If no problems were found, refer to Inactive Trouble Code Information. See INACTIVE TROUBLE CODE CONDITION  .