LEMON Manuals: Even more car manuals for everyone

Test FC-9A - O2S Stays Above Center (Rich) (DTC 52)

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Using DRB-II, set engine speed to 1500 RPM. Read O2 sensor voltage value. If O2 sensor voltage is always less than 0.5 volt, go to step 3). If O2 sensor voltage is always more than 0.5 volt, check for short to voltage from 12-volt O2 heater feed circuit (Dark Green/Black wire).
  2. Check connectors for dirt and grease build-up. Repair as required. Perform VERIFICATION PROCEDURE VER-2. If connectors are okay, a condition causing engine to run rich is indicated. Go to TEST NF-1A.
  3. At this time, condition required to set fault is not present. O2S STAYS ABOVE CENTER (RICH) fault sets if O2 sensor output voltage stays more than 0.5 volt, but less than 1.2 volts, without changing for more than 8 minutes. Possible causes are: high fuel pressure, other engine sensor calibrations, ignition system failure, or fuel contamination. Go to TEST NF-1A.