LEMON Manuals: Even more car manuals for everyone

Test FC-30C - A/C Clutch Relay Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
NOTE: A/C clutch relay is supplied voltage from radiator fan relay.
  1. Remove A/C clutch relay. Install a known good A/C clutch relay. DO NOT  use radiator fan relay. If known good A/C clutch relay is clicking, replace original A/C clutch relay. Perform VERIFICATION PROCEDURE VER-2. If known good A/C clutch relay is not clicking, remove known good A/C clutch relay. Put DRB-II in voltmeter mode.
  2. Ensure A/C clutch relay actuation test is still running. Using DRB-II, check voltage on A/C clutch relay connector, ignition feed circuit (Light Green wire). If voltage is less than 10 volts, repair open in Light Green wire. Perform VERIFICATION PROCEDURE VER-2.
  3. If voltage is more than 10 volts, turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Put DRB-II in ohmmeter mode. Using DRB-II, check resistance of A/C clutch relay connector, control circuit (Dark Blue/Orange wire). If resistance is less than 5 ohms, repair short to ground in Dark Blue/Orange wire. Perform VERIFICATION PROCEDURE VER-2.
  4. If resistance is more than 5 ohms, using an external ohmmeter, check resistance of control circuit (Dark Blue/Orange wire) between A/C clutch relay connector and PCM connector terminal No. 34. If resistance is more than 5 ohms, repair open in Dark Blue/Orange wire. Perform VERIFICATION PROCEDURE VER-2. If resistance is less than 5 ohms, replace PCM. Perform VERIFICATION PROCEDURE VER-2.