LEMON Manuals: Even more car manuals for everyone

Test FC-24A - EGR System Failure (DTC 32)

  1. Start engine. Allow engine to idle for 2 minutes. Disconnect vacuum supply hose to EGR solenoid. Connect a vacuum gauge to disconnected hose. If vacuum gauge reading is less than 10 in. Hg, repair vacuum supply hose to EGR solenoid.
  2. If vacuum gauge reading is more than 10 in. Hg, reconnect vacuum hose to EGR solenoid. Disconnect vacuum hose from EGR valve. Connect a vacuum gauge to disconnected hose. While observing vacuum gauge, momentarily increase engine speed to more than 2000 RPM.
  3. If vacuum gauge reading is more than 5 in. Hg when throttle is opened, go to next step. If vacuum gauge reading is less than 5 in. Hg when throttle is opened, replace EGR valve assembly.
  4. Remove vacuum gauge. Connect a vacuum pump to EGR valve nipple. With engine idling, slowly apply vacuum to EGR valve while observing engine idle speed. If engine idle is rough or stalls when vacuum is applied, go to step 6).
  5. If engine does not idle rough or stall when vacuum is applied, remove EGR valve and inspect manifold and tube for restrictions. Repair as required. Perform VERIFICATION PROCEDURE VER-2. If no restrictions are found, replace EGR valve assembly. Perform VERIFICATION PROCEDURE VER-2.
  6. If engine idled rough or stalled when vacuum was applied in step 4), turn ignition off. Apply vacuum to EGR valve nipple. Observe vacuum gauge. If vacuum does not hold for at least 10 seconds, replace EGR valve assembly. Perform VERIFICATION PROCEDURE VER-2. If vacuum holds for at least 10 seconds, go to next step.
  7. At this time, condition required to set fault is not present. EGR SYSTEM FAILURE fault occurs when Powertrain Control Module (PCM) performs a test of EGR system and monitors O2 sensor signal for a change. Possible causes are: EGR valve not opening, EGR transfer tube blocked, or EGR passage in manifold blocked. Go to next step.
  8. Inspect vacuum hoses and connectors. Repair as required. Perform VERIFICATION PROCEDURE VER-2. If vacuum hoses and connections are okay, see INACTIVE FAULT CONDITION. Perform VERIFICATION PROCEDURE VER-2.