Cold DRIVEABILITY Test 2B - Choke Valve Angle Check (4-Bbl.)
- Remove air cleaner assembly. Attach a rubber band between the intermediate choke shaft and air horn. Open throttle to allow choke valve to close. Install choke angle gauge to choke plate. Rotate degree scale until pointer is set to zero. Center leveling bubble.
- Rotate scale to 25° angle. Disconnect vacuum hose from choke vacuum diaphragm. Connect a vacuum pump to the choke vacuum diaphragm. Apply 18 in. Hg vacuum. Choke valve should open and the angle gauge centering bubble should be level.
- If choke valve opens and centering bubble is level, proceed to COLD DRIVEABILITY TEST 3 . Adjust choke valve angle as necessary. If choke valve does not open, replace choke diaphragm or repair linkage as necessary.