LEMON Manuals: Even more car manuals for everyone

Ignition Timing

CAUTION: Timing light secondary connection should be made with inductive pick-up. Do not puncture cables, boots, or nipples with test probes.
  1. Connect timing light to No. 1 plug wire of magnetic timing unit to probe receptacle. Connect jumper wire between carburetor switch and ground. On 2-Bbl carbureted models, disconnect the vacuum hose to SSC. Connect tachometer to engine.
  2. On 5.2L 2-Bbl models, disconnect and plug Spark Control Computer (SCC) vacuum hose. On all models, set parking brake. Shift transmission to "N". Start engine and warm to operating temperature. If necessary, adjust curb idle speed.
  3. With engine running at or below curb idle RPM, check timing at timing plate. Adjust timing by loosening distributor hold-down bolt and turning distributor housing.
  4. After timing has been set, recheck curb idle and adjust if necessary. Turn off engine. Disconnect timing equipment and remove tachometer. Reconnect jumper wire.
Fig 1: Grounding Carburetor Switch
G50I15956Courtesy of CHRYSLER MOTORS.
NOTE: The magnetic timing probe receptacle is located 10° ATDC. Do not use this to check timing with conventional timing light.
IGNITION TIMING SPECIFICATIONS (1)

Application Specification
5.2L
2-Bbl. 5-9 @ 680
4-Bbl. 14-18 @ 750
(1) Degrees BTDC @ RPM.