LEMON Manuals: Even more car manuals for everyone

Current Output Test

  1. Verify that ignition is off and disconnect negative battery cable. Disconnect output wire from alternator "BATT" terminal. Using a 0-100 amp ammeter, connect positive test lead to alternator "BATTERY" terminal and negative test lead to disconnected alternator output wire.
  2. Using a voltmeter, connect positive test lead to disconnected alternator output wire and negative lead to ground. Disconnect voltage regulator connector. Connect a jumper wire from Green wire to ground.
    CAUTION: DO NOT  allow Blue J2 wire to be connected ground. DO NOT  spread connector terminals with jumper wire.
  3. Attach negative battery cable and connect tachometer to engine. Put Variable Carbon Pile Rheostat ("OPEN" or "OFF" position), between battery terminals. Start engine. With engine speed at 900 RPM, adjust carbon pile until voltmeter reads 13 volts.
  4. DO NOT  allow voltage to exceed 16 volts. Ammeter reading should be within specifications. See ALTERNATOR SPECIFICATIONS  table. If reading is less than specified, replace alternator or remove and bench test.
Fig 1: Chrysler Alternator Mounting Arrangement
G7915Courtesy of CHRYSLER MOTORS.