Cold Dr5 - Throttle Position Sensor
- Connect voltmeter negative lead to a good ground, and attach its positive lead to cavity No. 13 of 13-wire ECU connector. Turn ignition switch to "RUN" position. Check voltage with the throttle closed and open. Voltage should be 0-1 volts with throttle closed; 3-5.5 volts with throttle wide open.
- If voltage is as specified, go to COLD DR6 - THERMO VALVE . If voltage is not to specifications, turn ignition switch off and disconnect 4-wire carburetor connector. Connect ohmmeter leads to Orange and Light Green/Red wires. Resistance should be 3500-6500 ohms with throttle closed and 100-1000 ohms with throttle wide open. If not, replace throttle position sensor.
- If resistance was okay, connect ohmmeter leads to cavity Nos. 3 and 13 of 13-wire connector. Resistance should be 3500-6500 ohms with throttle closed and 100-1000 ohms with throttle wide open. If okay, replace ECU. If not okay, repair open wires to throttle sensor.