Test NS1
NOTE:
Before replacing major components, be sure connector pins or cavities are not damaged, preventing proper voltage readings.
- Remove wire from any spark plug and insert insulated screwdriver in terminal. Hold screwdriver shaft 1/4" from good engine ground. Crank engine. A good spark should result, as long as engine is cranked. If spark results, proceed to NS2.NOTE: Handle 1-2 sparks as no spark.
- If no spark occurred, remove ignition coil wire from distributor cap. Hold coil wire 1/4" from a good engine ground. Have an assistant crank engine. A good spark should result. Handle 1-2 sparks as no spark. If spark is okay, check distributor cap and rotor. If no spark occurred, check coil wire.
- If coil wire was okay, remove throttle body air intake hose. Have an assistant crank engine and check fuel spray from injector. If spray is okay, proceed to NS6. If no fuel spray occurred, proceed to NS13.