LEMON Manuals: Even more car manuals for everyone

Limp-In Mode Test No. 6

  1. Turn ignition off. Disconnect both logic module connectors. Connect ohmmeter to White logic module connector cavity No. 2 and Black logic module connector cavity No. 8. There should be continuity. The resistance value is unimportant, just ensure there is continuity. If there is continuity, proceed to step 3).
  2. If there is no continuity, disconnect coolant sensor connector. Connect ohmmeter to Black logic module connector cavity No. 8 and Tan/White wire in coolant sensor connector. There should be continuity. If there is continuity, proceed to step 6). If there is no continuity, repair wire to cavity No. 8 for an open circuit to coolant sensor connector.
  3. Connect ohmmeter to Black logic module connector cavity No. 8 and ground. There should be no continuity. If there is no continuity, proceed to step 5). If there is continuity, disconnect coolant sensor connector.
  4. Connect ohmmeter to Tan/White wire in coolant sensor connector and ground. There should not be continuity. If there is continuity, repair wire to coolant sensor for a short to ground. If there is no continuity, replace coolant sensor.
  5. Reconnect both logic module connectors. Disconnect coolant sensor connector. Connect voltmeter to Tan/White wire in coolant sensor connector and ground. Turn ignition switch to "RUN" position. Voltmeter reading should be 4.5-5.5 volts. If voltage reading is not okay, replace logic module. If voltage reading is okay, proceed to next step.
  6. Turn ignition off. Connect ohmmeter to coolant sensor terminals. Ohmmeter reading should be 300-12,000 ohms. If resistance is not within specifications, replace coolant sensor.
  7. If resistance reading is okay, disconnect White logic module connector. Connect ohmmeter to White logic module connector cavity No. 2 and White/Light Blue wire in coolant sensor connector. There should be continuity. If there is continuity, check wire terminal in coolant sensor connector to ensure it is contacting coolant sensor terminal.
  8. Ensure connector is installed correctly. If there is no continuity, repair wire for an open circuit to wiring harness splice.