Limp-In Mode Test No. 5
- Turn ignition off. Disconnect Black logic module connector. Connect voltmeter to Black logic module connector cavity No. 5 and ground. Turn ignition switch to "RUN" position. Voltmeter reading should be .3-1.8 volts. If voltages is okay or is zero volts, proceed to step 3).
- If voltage is greater than 1.8 volts, turn ignition off. Disconnect White logic module connector. Disconnect 6-way connector from throttle body. Connect ohmmeter to Orange/White and Orange/Dark Blue wires in 6-way harness connector. There should not be continuity. If there is continuity, repair short in wiring to 6-way connector.
- Turn ignition off. Disconnect White logic module connector. Reconnect 6-way connector at throttle body. Connect ohmmeter to White logic module connector cavities No. 2 and No. 20. Ohmmeter reading should be 3000-7000 ohms. If resistance reading is okay, proceed to step 8). If resistance is greater than 7000 ohms, but not open, replace throttle position sensor.
- If resistance is less than 3000 ohms, but not zero, replace throttle position sensor If there is an open circuit, proceed to step 6). If there is zero ohms resistance, disconnect throttle body 6-way connector.
- Connect ohmmeter to Black/Light Blue and Orange/White wire in harness 6-way connector. There should be no continuity. If there is no continuity, replace throttle position sensor If there is continuity, repair short in wiring to throttle body 6-way connector.
- Disconnect throttle body 6-way connector. Connect ohmmeter to White logic module connector cavity No. 2 and Black/Light Blue wire in harness 6-way connector. There should be continuity. If there is no continuity, repair wiring for open circuit to wiring harness splice.
- If there is continuity, connect ohmmeter to White logic module connector cavity No. 20 and Orange/White wire in harness 6-way connector. There should be continuity. If there is continuity, replace throttle position sensor If there is no continuity, repair wiring for an open circuit to logic module.
- Reconnect connectors to module. Connect voltmeter toOrange/White wire in harness 6-way connector and ground. Do not disconnect connector. Turn ignition switch to "RUN" position. Voltmeter reading should be 4.5-5.5 volts. If voltage is okay, proceed to step 10).
- If voltage reading is not okay, turn ignition off. Disconnect White connector from logic module. Disconnect 6-way connector at throttle body. Connect ohmmeter between White logic module connector cavity No. 20 and ground. There should be no continuity. If there is no continuity, replace logic module. If there is continuity, repair wire to connector cavity No. 20 for a short to ground.
- Turn ignition off. Disconnect Black logic module connector. Connect voltmeter to Black logic module connector cavity No. 5 and ground. Turn ignition switch to "RUN" position. Press accelerator pedal to floor. Voltmeter reading should increase as pedal is pressed to floor. If voltage increases, replace logic module.
- If voltage does not increase, turn ignition off. Disconnect throttle body 6-way connector. Connect ohmmeter to Black logic module connector cavity No. 5 and Orange/Dark Blue wire in harness 6-way connector. There should be continuity. If there is no continuity, repair wire to connector cavity No. 5 for an open circuit to harness 6-way connector.
- If there is continuity, connect ohmmeter to Orange/Dark Blue wire in 6-way harness connector and ground. There should be no continuity. If there is continuity, repair wiring to 6-way connector for a short to ground. If there is no continuity, replace throttle position sensor.