LEMON Manuals: Even more car manuals for everyone

Limp-In Mode Test No. 3

  1. Turn ignition off. Disconnect White logic module connector. Disconnect connector from MAP sensor. Connect ohmmeter to logic module connector cavity No. 2 and Black/Light Blue wire in MAP sensor connector. There should be continuity. If there is no continuity, repair wire to MAP sensor for an open circuit to wiring harness splice.
  2. If there is continuity, disconnect Black logic module connector. Connect ohmmeter to Black logic module connector cavity No. 4 and Dark Green/Red wire in MAP sensor connector. Ohmmeter should show continuity. If there is no continuity, repair wire to MAP sensor for an open circuit to logic module.
  3. If there is continuity, reconnect both logic module connectors. Connect voltmeter to MAP sensor connector Dark Green/Red wire and ground. Turn ignition switch to "RUN" position. Voltmeter reading should be 4.5-5.5 volts. If voltmeter reading is okay, replace MAP sensor. If voltmeter reading is not okay, replace logic module.