LEMON Manuals: Even more car manuals for everyone

Limp-In Mode Test No. 2

  1. Turn ignition off. Connect voltmeter to Violet/White wire in MAP sensor connector and ground. Do not disconnect connector from MAP sensor. Turn ignition switch to "RUN" position. Voltmeter reading should be 4.5-5.5 volts. If voltage reading is not okay, proceed to step 3).
  2. If voltage reading is okay, turn ignition off. Disconnect vacuum hose from MAP sensor. Connect a vacuum pump to MAP sensor. Turn ignition switch to "RUN" position. Apply 15 in. Hg vacuum. Start engine. Power Loss Lamp on instrument panel should be off. If Power Loss Lamp is off, repair hose for loss of vacuum supply to MAP sensor. If Power Loss Lamp is on, replace MAP sensor.
  3. Disconnect connector from MAP sensor. Voltmeter reading should be 4.5-5.5 volts. If voltage reading is okay, replace MAP sensor. If voltmeter reading is not okay, connect voltmeter to White logic module connector cavity No. 4 and ground. Do not disconnect connector from logic module. Voltmeter reading should be 4.5-5.5 volts.
  4. If voltmeter reading is okay, repair wire to logic module connector cavity No. 4 for an open circuit to MAP sensor. If voltage reading is not okay, replace logic module.