LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. Apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim before cutting out the stationary window.
  2. Open the hood.
  3. Windshield Wiper Arm - Remove - Windshield Wiper Arm Replacement
  4. Air Inlet Grille Panel - Remove - Air Inlet Grille Panel Replacement
  5. Inside Rearview Mirror - Remove - Inside Rearview Mirror Replacement
  6. Inside Air Moisture and Windshield Temperature Sensor - Remove - Inside Air Moisture and Windshield Temperature Sensor Replacement
  7. GM5138066Courtesy of GENERAL MOTORS COMPANY

    Front View Camera (1) - Remove - Front View Camera Replacement

  8. Cover to protect the following parts from broken glass:
    • Upper Dash Pad
    • The defroster outlets and A/C outlets
    • The seats and carpeting
  9. Remove the lower windshield supports from the cowl panel, if equipped.
  10. GM379905Courtesy of GENERAL MOTORS COMPANY

    Using the appropriate tool, carefully cut around the lace (1), start in the center working from side to side of the window to access the urethane adhesive bead, if equipped.

  11. NOTE:

    Keep the cutting edge of the tool against the window.

  12. This will allow the urethane adhesive to be separated from the windshield.
    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
    • Use commercially available glass cutting tool.
  13. GM5134277Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, remove the windshield (1) and locating pin (2) from the vehicle.