LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    NOTE:

    It may be necessary to transfer the wire harness retainers (2) to the new bracket.

  1. GM4074601Courtesy of GENERAL MOTORS COMPANY

    Set the rear side door outside handle bracket counter balance (3) as follows:

    1. The outside door handle Can Not be install until the counter balance (3) is reset.
    2. Grasp the front side door outside handle bracket (1) with one hand.
    3. From the back side of the counter balance (3) push forward on the counter balance until it can be held in place using the bracket clip (2).
  2. GM4080787Courtesy of GENERAL MOTORS COMPANY

    Install the rear side door outside handle bracket cable (2) to the counter balance (4).

  3. Install the rear side door outside handle bracket cable (2) in the retainers (1) of bracket (3).
  4. GM3767455Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    NOTE:
    • Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance can't Not be reset after the latch and handle bracket has been reinstalled in the door.
    • Bracket should be slid full rearward prior to tightening bracket screw.

    Install the rear side door outside bracket screw (1) to the door (2) and tighten to 5 N. m (44 lb in).

  5. Rear Side Door Outside Handle Replacement  - Install
  6. Rear Side Door Window Rear Channel Replacement - Install
  7. Ensure that the door system operates properly before installing the trim.