LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    NOTE:

    It may be necessary to transfer the wire harness retainers from the old handle bracket.

  1. GM4074601Courtesy of GENERAL MOTORS COMPANY

    Reset the front side door outside handle bracket counter balance as follows:

    1. The outside door handle Can Not be install until the counter balance (3) is reset.
    2. Grasp the front side door outside handle bracket (1) with one hand.
    3. From the back side of the counter balance (3) push forward on the counter balance until it can be held in place using the bracket clip (2).
  2. Front Side Door Lock Cylinder Replacement  - Install
  3. GM4074437Courtesy of GENERAL MOTORS COMPANY

    Install the front side door outside handle bracket cable (2) to the counter balance (4).

  4. Install the front side door outside handle bracket cable (2) in the retainers (3) of bracket (1).
  5. GM4081300Courtesy of GENERAL MOTORS COMPANY

    Install the front side door lock rod (2) to the front side door lock cylinder (1).

  6. GM3767455Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Install the front side door outside bracket screw (1) to the door (2) and tighten to 5 N. m (44 lb in)

    NOTE:
    • Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance Can Not be reset after the latch and handle bracket has been reinstalled in the door.
    • Bracket should be slid full rearward prior to tightening bracket screw.
  7. Front Side Door Outside Handle Replacement (with Passive Entry Passive Start) Front Side Door Outside Handle Replacement (without Passive Entry Passive Start)  - Install
  8. Front Side Door Window Rear Channel Replacement - Install
  9. Ensure the door system operates properly.