LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    NOTE:

    It may be necessary to transfer the wire harness retainers from the old handle bracket.

  1. GM4138385Courtesy of GENERAL MOTORS COMPANY

    Reset the rear side door outside handle bracket counter balance as follows:

    1. The outside door handle Can Not be install until the counter balance is reset.
    2. Grasp the rear side door outside handle bracket (1) with one hand.
    3. From the back side of the counter balance (2) push forward on the counter balance until it can be held in place using the bracket clip (3).
  2. GM4138206Courtesy of GENERAL MOTORS COMPANY

    Rear side door outside handle bracket cable (1) @ counter balance (2) - Install

  3. GM4138205Courtesy of GENERAL MOTORS COMPANY

    Rear side door outside cable (1) @ retainers (2) - Install

  4. GM4138304Courtesy of GENERAL MOTORS COMPANY

    Raise the rear side door outside handle bracket (1) up to the outside door opening.

  5. GM4138212Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Rear side door outside handle bracket screw (1) - Install and tighten5 N. m (44 lb in)

  6. NOTE:
    • Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance Can Not be reset after the handle bracket has been reinstalled in the door.
    • Bracket should be slid full rearward prior to tightening bracket screw.
  7. Rear Side Door Lock Cylinder Opening Cover Replacement  - Install
  8. Rear Side Door Outside Handle Replacement  - Install
  9. Rear Side Door Window Channel Rear Retainer Replacement - Install
  10. Ensure the door system operates properly.