Installation Procedure
- Transfer the lock cylinder.
Reset the front side door outside handle bracket counter balance as follows:
- The outside door handle Can Not be install until the counter balance is reset.
- Grasp the front side door outside handle bracket (1) with one hand.
- From the back side of the counter balance (2) push forward on the counter balance until it can be held in place using the bracket clip (3).
Front side door outside handle bracket cable (1) @ counter balance (2) - Install
Front side door outside cable (1) @ retainers (2) - Install
Front Side Door Lock Rod(1) @ Front Side Door Lock Cylinder(2) - Install
Raise the front side door outside handle bracket (1) up to the outside door opening.
- CAUTION:
Refer to Fastener Caution .
Front side door outside handle bracket screw (1) - Install and tighten 5 N. m (44 lb in)
- Ensure that the counter balance is reset and locked in the detent of the handle bracket. The counter balance Can Not be reset after the handle bracket has been reinstalled in the door.
- Bracket should be slid full rearward prior to tightening bracket screw.
- Front Side Door Lock Cylinder Opening Cover Replacement - Install
- Front Side Door Outside Handle Replacement (Base) , or Front Side Door Outside Handle Replacement (Pass Key Entry ATH) - Install
- Rear Side Door Window Channel Rear Retainer Replacement - Install
- Ensure the door system operates properly.
NOTE:
It may be necessary to transfer the wire harness retainers from the old handle bracket.
NOTE: