LEMON Manuals: Even more car manuals for everyone

Removal Procedure

  1. Place the ignition in the OFF position.
  2. Remove the air cleaner outlet duct. Air Cleaner Outlet Duct Replacement (LT1)Air Cleaner Outlet Duct Replacement (LT4)Air Cleaner Outlet Duct Replacement (LT5)
  3. Thoroughly clean the area surrounding the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) of any accumulated dirt and debris.
  4. Disconnect the EBCM electrical connector.
  5. GM3318475Courtesy of GENERAL MOTORS COMPANY

    Disconnect the left rear brake pipe fitting nut (1).

  6. Cap the brake pipe and plug the BPMV outlet port to prevent brake fluid loss and contamination.
  7. Disconnect the right rear brake pipe fitting nut (2).
  8. Cap the brake pipe and plug the BPMV outlet port to prevent brake fluid loss and contamination.
  9. GM3318479Courtesy of GENERAL MOTORS COMPANY

    Disconnect the left front brake pipe fitting nut (1).

  10. Cap the brake pipe and plug the BPMV outlet port to prevent brake fluid loss and contamination.
  11. Disconnect the right front brake pipe fitting nut (2).
  12. Cap the brake pipe and plug the BPMV outlet port to prevent brake fluid loss and contamination.
  13. GM3318480Courtesy of GENERAL MOTORS COMPANY

    Disconnect the master cylinder secondary brake pipe fitting nut (1).

  14. Cap the brake pipe and plug the BPMV inlet port to prevent brake fluid loss and contamination.
  15. Disconnect the master cylinder primary brake pipe fitting nut (2).
  16. Cap the brake pipe and plug the BPMV inlet port to prevent brake fluid loss and contamination.
  17. GM3318482Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    It is not necessary to remove the BPMV assembly nuts.

    Loosen the 2 BPMV assembly nuts (1).

  18. GM3318484Courtesy of GENERAL MOTORS COMPANY

    Lift the BPMV assembly (1) straight upward and release the assembly from the BPMV bracket.

  19. GM2141671Courtesy of GENERAL MOTORS COMPANY

    Remove the EBCM bolts (1).

  20. GM2141673Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not attempt to lever or pry the components apart.

    Separate the EBCM (1) from the BPMV.

  21. Clean the sealing surfaces of the EBCM with denatured alcohol and allow to dry.