Installation Procedure
If replacing the tank, remove the fuel pump module and the evaporative emission canister. Refer to Fuel Tank Fuel Pump Module Replacement , and Evaporative Emission Canister Replacement .
- Transfer parts as necessary.
- Raise the fuel tank (1).
- CAUTION:
Refer to Fastener Caution .
Support the fuel tank with a suitable stand.
- Position the fuel tank straps (2) onto the fuel tank.
- Install the fuel tank strap fasteners (1) and tighten to 22 N.m (16 lb ft).
Connect the fuel and evaporative emission connectors (1). Refer to Plastic Collar Quick Connect Fitting Service .
Connect the vent hose (1).
- Tighten the hose clamps (2) to 3.5N.m (31 lb in) and slide the filler hose off the fuel tank.
Connect the fuel pump harness electrical connector (3).
- Install the harness cover (2) and tighten the cover fasteners (1).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .