LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. If the steering wheel airbag was deployed, replace the steering column. Steering Column Replacement 
  2. Remove Turn Signal Switch Bracket. Turn Signal Switch Bracket Replacement .
  3. Unlock the steering column adjustment lever before removing the steering column from the vehicle:
    • Replace the steering column if the adjustment lever cannot be fully unlocked.
    • In the vehicle, with the adjustment lever unlocked, press forward on the steering wheel with a force of 50 N (11 lbf)-100 N (22 lbf) while adjusting the steering column up and down. If there is evidence of ratcheting teeth or the steering column will not adjust up and down, replace the steering column. Steering Column Replacement 
  4. Remove Steering Column. Steering Column Replacement 
  5. Rotate the steering column shaft and verify the shaft turns freely and without interference.
  6. Fig 1: E/A Strap Retaining Screw
    GM4002766Courtesy of GENERAL MOTORS COMPANY
  7. Verify there is no visual damage to the Energy Absorbing (E/A) strap and that the E/A strap is not deformed. On Rake and Telescope steering columns, verify the E/A strap retaining screw (1) is centered within +/- 0.7 mm (0.028 in) to the screw access hole (a) in the E/A strap.
  8. Fig 2: Telescope Bumper
    GM4002768Courtesy of GENERAL MOTORS COMPANY
  9. Verify that the telescope bumper (1) on the E/A strap does not contact the upper or lower surfaces of the lower steering column jacket opening during telescoping of the steering column.
  10. Fig 3: Measure Length Of Upper Steering Shaft
    GM4002769Courtesy of GENERAL MOTORS COMPANY
  11. Measure the length of the upper steering shaft from the end of the shaft to the steering column upper jacket:
    • Rake Only: The measured length (a) must be greater than 61 mm (2 in).
    • Rake and Telescope: The measured length (a) must be greater than 61 mm (2 in).
  12. Fig 4: Measure Length Of Upper Steering Column Jacket
    GM4002770Courtesy of GENERAL MOTORS COMPANY
  13. Telescope the steering column to the full extended position and measure the length of the upper steering column jacket and lower steering column jacket INCLUDING the lower bearing adapter:
    • Rake Only: The measured length (a) must be greater than 365 mm (14 in).
    • Rake and Telescope: The measured length (a) must be greater than 385 mm (15 in).
  14. If the steering column fails ANY of the measurement specifications, replace the steering column. Steering Column Replacement 
  15. If the steering column passes ALL of the measurement specifications, install the OLD steering column and reassemble all components. Steering Column Replacement