Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
Courtesy of GENERAL MOTORS COMPANY
- Loosen the park brake cable locknut (1) at the equalizer to relieve tension on the park brake cable.
Courtesy of GENERAL MOTORS COMPANY
- Disconnect the front park brake cable (1) from the rear park brake cable.
- Using the J 37043
parking brake cable release tool , remove the front park brake cable from the park brake cable bracket on the body by compressing the locking tabs on the cable conduit (2).
- Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Enclave)
, Instrument Panel Insulator Panel Replacement - Left Side (Acadia)
, Instrument Panel Insulator Panel Replacement - Left Side (Traverse)
.
- Remove the driver side front carpet retainer. Refer to Front Side Door Opening Floor Carpet Retainer Replacement
.
Courtesy of GENERAL MOTORS COMPANY
- Remove the 2 nuts and the driver footrest.
Courtesy of GENERAL MOTORS COMPANY
- Lift the driver floor carpet to expose the front park brake cable routing clip.
- Release the park brake cable routing clip from the floor stud.
Courtesy of GENERAL MOTORS COMPANY
- Release the front park brake cable pass through grommet.
Courtesy of GENERAL MOTORS COMPANY
- Disconnect the front park brake cable from the park brake pedal clevis (1).
- Remove the front park brake cable from the park brake pedal assembly by compressing the locking tabs on the cable conduit (2).
- Remove the front park brake cable assembly.