LEMON Manuals: Even more car manuals for everyone

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

Front Fog Lamp Switch Malfunction

  1. Ignition OFF, disconnect the harness connector at the S30 headlamp switch.
  2. Ignition ON, verify that a test lamp illuminates between the 12 V reference circuit terminal 1 and ground.
    • If the test lamp does not illuminate, test the 12 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal and the circuit fuse is open, test the signal circuit terminal 12 for a short to ground.
  3. Verify the scan tool Front Fog Lamps Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 12 for a short to voltage. If the circuit tests normal, replace the K9 BCM.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 12 and the 12 V reference circuit terminal 1. Verify the scan tool Front Fog Lamps Switch parameter is Active.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  5. If all circuits test normal, test or replace the S30 headlamp switch.

Front Fog Lamps Malfunction

  1. Ignition OFF, disconnect the X2 harness connector at the X50A underhood fuse block.
  2. Connect a test lamp between the control circuit terminal 19 and B+.
  3. Command the Front Fog Lamps Command ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K9 BCM.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K9 BCM.
  4. Ignition OFF, connect the X2 harness connector at the X50A underhood fuse block. Disconnect the harness connector at the appropriate E29 Fog Lamp - Front.
  5. Test for less than 5 Ω between the ground circuit terminal A and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  6. Connect a test lamp between the control circuit terminal B and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  7. Command the Front Fog Lamps Command ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the E29 Fog Lamp - Front.
    • If the test lamp is always OFF and the circuit fuse is good, test the control circuit for an open/high resistance. If the circuit tests normal, test or replace the E29 Fog Lamp - Front.
    • If the test lamp is always OFF and the circuit fuse is open, test the control circuit for a short to ground. If the circuit tests normal, test or replace the E29 Fog Lamp - Front.
  8. If all circuits test normal, test or replace the X50A underhood fuse block.