Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: Listen for an audible click when the crank relay operates. Turn the ignition switch back and forth from the ON to START positions. Repeat this as necessary.
- 3: This step tests the ground circuit of the crank relay.
- 4: This step verifies that the ECM is providing 12 volts to the control circuit of crank relay.
- 5: This step tests for an open in the control circuit to the crank relay.
DTC P0615
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Starting and Charging Schematics Connector End View Reference: Power and Grounding Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Starter Solenoid Does Not Click |
| 3 |
|
Go to Step 4 | Go to Step 8 |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Test the control circuit of the crank relay for an open or a high resistance. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 6 | Inspect for poor connections at the starter relay. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 7 | Inspect for poor connections at the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 8 | Repair the ground circuit of the crank relay. Refer to Connector Repairs
. Did you complete the repair? |
Go to Step 11 | - |
| 9 | Replace the crank relay. Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the ECM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 11 | - |
| 11 |
|
Go to Step 2 | System OK |