LEMON Manuals: Even more car manuals for everyone

Testing Procedure

  1. Turn OFF the ignition.
  2. Relieve the fuel pressure. Refer to FUEL PRESSURE RELIEF ..
  3. Disconnect the chassis fuel hose from the engine compartment fuel pipe. Refer to FUEL HOSE/PIPES REPLACEMENT - CHASSIS .
  4. Install the J 37287  between the chassis fuel hose and the engine compartment fuel pipe. See Special Tools .
  5. Open the valve on the J 37287  . See Special Tools .
  6. Turn ON the ignition, with the engine OFF.
  7. Command the fuel pump relay ON with a scan tool.
  8. Bleed the air from the J 34730-1A  .
  9. Command the fuel pump relay ON and then OFF with a scan tool.
  10. Close the fuel feed pipe shut-off valve.
  11. Monitor the J 34730-1A  for 1 minute.
    • If the fuel pressure remains constant, replace the fuel sender assembly.
    • If the fuel pressure does not remain constant, locate and replace the leaking fuel injectors.