LEMON Manuals: Even more car manuals for everyone

Installation Procedure

    Fig 1: Removing/Installing Knock Sensor
    GM1587771Courtesy of GENERAL MOTORS CORP.
  1. Install and tighten the bank 2 knock sensor (2).

    Tighten:   Tighten the nuts to 25 Nm (18 lb ft).

  2. Fig 2: Identifying Knock Sensor (KS) & Crankshaft Position (CKP) Sensor Connectors
    GM1679872Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connector (1) to the knock sensor.
  4. Install the splash shield. Refer to Splash Shield Replacement - Engine .
  5. Install the right front tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .